• The NAWCC Museum and Library & Research Center are currently open. Please check the Visiting Schedule for Days and Hours at the bottom of the Visit Page.

Problem with KWM Bushing Machine

manfromblan

Registered User
NAWCC Member
Jan 29, 2005
67
2
8
Blanchester, Ohio
Country
Region
Just received a new center shaft (timesavers) for my bushing machine.
Have had this machine 30 years & have replaced the shaft couple of times before.
The one I just got is the OD of the shaft is too large to fit my machine, also the tool holder end the ID is too small & unable to accept any of the tools.
This shaft is chrome plated which I think has caused the problem. Past ones have never been plated.
Has something changed with these machines? Called (TS) & they said that was all they had.
Anyone had this issue or know of another source for this part, thanks
 

bruce linde

Technical Admin
Staff member
NAWCC Member
Nov 13, 2011
7,917
1,064
113
oakland, ca.
clockhappy.com
Country
Region
sounds like it's just the wrong part.... perhaps bergeon?

i wonder if it's available from merritts or some other source.... but i'd return it.
 
  • Like
Reactions: NEW65