• Upcoming updates
    Over the next couple of weeks we will be performing software updates on the forum. These will be completed in small steps as we upgrade individual software addons. You might occasionally see a maintenance message that will last a few minutes at most.

    If we anticipate an update will take more than a few minutes, we'll put up a notice with estimated time.

    Thank you!

peerless lathe tailstock chuck holder

1

107WestStreet

Anyone out there know where I can get one of these?
 

David Robertson

Registered User
Jan 6, 2003
1,525
10
38
Country
Region
107..

What kind of chuck are you wanting to hold? is it one you already have or one you are planning to get?

what kind of tailstock? collet holding or not?

David
 

Robert M.

Registered User
Nov 20, 2004
1,114
3
0
Whatever you need for your Peerless you can get from Harvey Schmidt.He's probably the largest pre-owned Lathe accessory dealer on the east coast,a real nice guy too.
Harvey Schmidt
http://www.toolpin.com
(718)969-0847
Flushing,N.Y.
I hope this is of some help to you.
Merry Christmas,Bob Fullerton
 

David Robertson

Registered User
Jan 6, 2003
1,525
10
38
Country
Region
You can hold the drill in the pin vise and feed it in by hand as long as you have started a dimple on center... don't really need the tailstock for this.. just keep the drill straight and level. Tailstock can be used as a "marker" for making sure you have the pin vise level.

David
 
  • Like
Reactions: Dave T

Forum statistics

Threads
179,056
Messages
1,570,559
Members
54,055
Latest member
Jabberwalky
Encyclopedia Pages
909
Total wiki contributions
3,088
Last edit
Swiss Fake by Kent