Clock Open Part for European clock case needed

[bonusbuilt1950]

II have a clock made by Gillett & Johston for Barraud & Lunds in the 1920's approximately. Anyway, my case is missing one of the medallions or rosettes that is recessed into the side of the case. I need one, but will buy a matching set, They measure 3-1/4 inch by 2-1/4 inch. They are roughly 1/4 inch thick. They are held in with 3 nail pushed in at an angle. I've attached a pic of the one I have still. If you can help or might know of a source, that would be great.

 

[Jeff Salmon]

This would be a rather simple repair, I think, for a craftsperson with a laser engraver. They could use the old one for a pattern, or you could probably have them made in brass (thinner). Try Etsy.