KWM Bushing Tool

[teacher08]

I have aquired a KWM Bushing Tool that uses a chuck similar to a drill chuck to hold the reamers and pushers. I need to get a new chuck. This chuck is held on the shaft with by a taper fit. It does not seem to be a Jacobs taper. Does anyone know what the taper is or where I can get another chuck?

 

[teacher08]

I have aquired a KWM Bushing Tool that uses a chuck similar to a drill chuck to hold the reamers and pushers. I need to get a new chuck. This chuck is held on the shaft with by a taper fit. It does not seem to be a Jacobs taper. Does anyone know what the taper is or where I can get another chuck?

 

[Charles E. Davis]

KWM reamers don't need a chuck. They fit in a hole of the rod with a slot to hold a pin that keeps the reamer in place. If you can obtain a rod that fits your tool you can easily adapt the end to fit your reamers by drilling it in a lathe.