Clock Construction Forum

Discussion in 'Clock Construction' started by Allan Wolff, Mar 24, 2011.

Thread Status:
Not open for further replies.
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.
  1. Allan Wolff

    Allan Wolff Moderator
    NAWCC Member

    Mar 17, 2005
    609
    34
    28
    Male
    Tulsa, OK
    Country Flag:
    Region Flag:
    The original "Construction of a Skeleton Clock" forum was put in place to cover the building of one particular clock. Since other clock construction projects have been discussed here as well, it was decided to open up the forum to Clock Construction in general.

    I have volunteered to moderate this forum and hope it will provide a valuable resource to anyone building their own clock or those who just enjoy reading about projects like this. Discussions and questions about clock building problems and sharing of tips and new ideas are also encouraged.

    So let the chips fly and have fun!

    Allan Wolff
     
    Noel Rieusset and James Matheson like this.
  2. hobaart

    hobaart Registered User

    Jul 23, 2011
    6
    0
    0
    maintenance/forklift repair
    cardboard box
    i have a jewelers regulator that has a kieninger 80 cm. drop for pendulum, mvmnt. has a graham dead beat with brass leader. can any one tell me where to measure from end to end to modify lire pendulum so that i'm at 80 cm.:confused:
     
  3. Darryn

    Darryn New Member

    Mar 3, 2010
    2
    0
    0
    Hello
    I am looking for plans to build a one month going spring driven mechanism. I don't really need the full plans for the frames and levers, ect but would like the gear train
    plans (number of teeth and sizes of the gears). Does anyone know where I can find some more info on this?

    Darryn Clark
     

Share This Page