Separate names with a comma.
I Try them to find the best
[ATTACH] [ATTACH] [ATTACH]
I will be giving this a try
All you had to do was turn the brass oval washer right or left and it would come out of the slot, then take the min. hand off turn the nut and...
Take the pendulum off
Hold the pendulum about 3" from the top end, Twist & bend above that, so it hangs straight.
Unless very thick plates.
I have a full set of pins, I want to try cutting the bushing with the pins used as cutters , Parallel bearing...
One side or three sides ?
Or two ?
Do you only Grind on One side ????????
Do you only Grind one side ????????
Thank you all so much.
Like I said I don't work on watches and I don't want to in the future either.
I just wanted to know a little about them....
Its time to severs this clock again, as you can see its been like 13 yrs.
it seems that the design on the rear plate is not engraved maybe painted...
This is maybe a closer look at one together.
LOOK very careful & maybe you can figure it out.
Balance With a V block
[ATTACH] [ATTACH] [ATTACH] [ATTACH]
See if this will for you ?
I have seen this so many times, I don't even try to take the hour hand off with out first putting a screwdriver between the back of the dial and...