Most visitors online was 4107 , on 14 Jan 2023
G
gordon
Latest activity Postings Media Post Areas About Post areas
-
-
Ggordon replied to the thread Weights for G. Becker clock?.Hello Willie and Jess Thank you for the quick reply. I will be looking for matching weights.
-
GHello All Does any one know what size weights go wit the movement in the photos? I have a T&S G. Becker clock that does not have its...
-
-
GHello All I have a G. Becker movement S/N 536404. Wondering when it was made if the S/N is enough information. It is a weight driven...
-
Ggordon replied to the thread Minute hand and hour hand bind at their center..Hello Roughbarked When the pin and washer are on and the minute hand is tighten on the end of the square on the shaft. There was no...
-
Ggordon replied to the thread Minute hand and hour hand bind at their center..Hello Roughbarked Thank you for the reply. Yes I did think about tightening the square on the minute hand hub. The minute hand hub...
-
Ggordon replied to the thread Minute hand and hour hand bind at their center..Hello Jeff T I desided to give another look a the psibility of adding a spacer to the center arbor that would move the hands out. So...
-
Ggordon replied to the thread Minute hand and hour hand bind at their center..Hello Jeff T I did not see any wittiness marks. Gordon
-
Ggordon replied to the thread Minute hand and hour hand bind at their center..Hello WOW Yes the hour hand i s touching the dial. The hope was that it would allow clearance for the minute hand. If the minute hand...
-
Ggordon replied to the thread Minute hand and hour hand bind at their center..Hello Escape Wheel and WOW Thank you for the replys. I must admit I too thought the problem may be with the dial needing to be closer...
-
-
Ggordon replied to the thread Minute hand and hour hand bind at their center..Hello Steven Neul Thank you for the reply. My offending hand goes on too far on its center arbor. Simular to your clock it is a poor...
-
Ggordon replied to the thread Minute hand and hour hand bind at their center..Hello All I am guessing no replies mean the change of the minute hand bushing is the clocks only hope. I have been hoping there was a...
-
GHello All I have a problem that I see as: "the center of the minute hand sits so deep on its minute arbor that it binds against the...
-
-
Ggordon replied to the thread Removing 100 year old Glazing?.Hello All MR George Waterhouse recommended using a soldering gun. I have found this method to be safe for the wooden door's frame.
-
-
Loading…
-
Loading…
-
Loading…
-
Loading…
-
Loading…
Know Your NAWCC Forums Rules!
RULES & GUIDELINES
RULES & GUIDELINES
Latest posts
-
-
-
-
George Mutter's Clock [Famous carpentry tool maker]- Latest: rmarkowitz1_cee4a1
-
Staff online
-
Philip MorrisChair, Museum Collections -
John CoteDirector
Forum statistics
- Threads
- 184,069
- Members
- 56,019
- Latest member
- jedmas
- Encyclopedia Pages
- 918
- Total wiki contributions
- 3,195
- Last edit
- Waltham's Canadian Railway Movements by Kent