Nice ones Rodalco :-)
Just with your oil bath movement - the oil wasn't just for making the unit run quietly but also for lubrication. I wouldn't run it without the oil!
Die zweigetrieb should be positioned at the bottom of the enclosure with the terminals on top & the oil level needs to cover...
If you notice just below the terminals & oil filler screw, there is a faint 24V printed there.
A word of warning Ant - be extremely careful with the coil wires. If you break them then (in my experience) kiss the thing goodbye.
These I'm guessing were probably made around the mid 80's so any...
I believe you are 100% re the oil bath movement for silencing (& possibly longevity) as this is where I had involvement with these clocks/movements.
I'll post a pic backing up our 24VDC in a minuteif I'm able to as a newbie.
Hi Ant - this is a long shot as your post is six years old now... however... I hope you didn't hook the terminals on the movement to any of the aforementioned voltages!
I have some limited experience with these movements & they were all 24V DC.
To get it to operate you would also need a master...