Separate names with a comma.
Jerry Kieffer, Do you use a DRO on your mill and what do you think of them for the Sherline mill and lathe? Thank you.
I believe you got the answer two time in the two post you have made and I guess you did not like the answer. I do not think that a third post is...
No I can not ID clocks but think there are nine clocks in the picture. Am I correct?
Oh I think it 10 clocks.
Steven G Conover in his BOOK 6 - SETH THOMAS, Has three pages of good information on the spring boxes. On page 33 he show an arbor that he made...
Thank you all for the watch pictures. I repair clocks from time to time. I am not a collector of clocks and do not go to the watch forum, so...
Nice to see the so many out to the Chapter 31 meeting yesterday. Not only were there ladies out but also a young girl. Hope she becomes a member...
Some are threaded. See if turning it will tighten it up.
Would turning the tool post 180 degrees, turning the tool holder so the clamp is on the top (up side down) and also turned the parting tool for...
kinsler33 I think you meant that one Horsepower (1 hp) equals 746 watts.
Okay that is 0.746 Kw:(
Thank you Robert G. for posting here. I think it is a good thing and hope you do this every month. Oldpassions looks like it would be a very...
Looks like a circuit board holder for putting parts on a pc board. Do the arms have slots?
Nice video. In 1931 the cost of these watches was high. It must have taken many hours of work to pay for a railroad watch.
Very Nice Work.
Thank you Roughbarked and Doc-Field for the reply's. Always something to learn. So it looks like parts suppliers(like Timesavers) do not carry...